How to use your phone as a bubble level
- Open this page on your phone. On iPhone, tap Tap to enable motion sensor and choose Allow.
- Choose how to hold it. Flat on surface for tables, shelves and appliances; On its edge for picture frames, shelf edges and door heads.
- Watch the bubble. Like a real spirit level, it drifts toward the high side. Raise the low side, or lower the high side, until the bubble sits in the center.
- Read the number. The big number is how far you are from level. The bubble turns green within 0.2°.
- Tap Hold to freeze the reading when the screen is hard to see.
Calibrate for the best accuracy
Phone cases and camera bumps can tilt a phone by a degree or more. Put the phone on a surface you know is level and tap Set as level; the offset is saved on your phone and used every time. Calibrate each mode separately, and each edge in edge mode.
No level surface to calibrate on? Use the flip test. Note the reading, turn the phone end-for-end on exactly the same spot, and read again. If both readings match, the surface is level. If not, the surface tilts by the average of the two readings, and the difference is your phone's error.
How far off level is that?
The same tilt, in the units builders and installers use:
| Degrees | Percent slope | Inches per foot | mm per metre |
|---|---|---|---|
| 0.1° | 0.17% | 1/32 in | 1.7 mm |
| 0.25° | 0.44% | 1/16 in | 4.4 mm |
| 0.5° | 0.87% | 3/32 in | 8.7 mm |
| 1° | 1.75% | 7/32 in | 17.5 mm |
| 2° | 3.49% | 13/32 in | 34.9 mm |
| 5° | 8.75% | 1 1/16 in | 87.5 mm |
What you can level with it
- Pictures, mirrors and TVs: edge mode, with the phone standing on the top edge of the frame.
- Shelves and cabinets: flat on the shelf for both directions at once, or edge mode along the front lip.
- Washing machines, dryers and fridges: flat on top. Adjust the feet until the bubble is green.
- Campers, RVs and trailers: flat on the floor or a counter, near the middle of the vehicle.
- Pool tables, desks and workbenches: check several spots; a surface can be level in one place and not another.
- Tripods and cameras: flat on the camera or tripod plate.
Need a number other than zero? The angle finder reads any tilt with roof pitch and percent slope, the angle meter measures the angle between two surfaces, and the online protractor measures angles on your screen.
How a phone level works
Your phone's accelerometer feels the pull of gravity along three directions. When the phone is perfectly level, all of gravity points straight through the screen; any tilt shifts a little of it sideways. The page turns that shift into an angle, smooths out hand shake, and moves the on-screen bubble the way a real bubble would float to the high end of a vial. Everything happens on your phone.
Frequently asked questions
How accurate is a phone bubble level?
After calibration, most phones read level to within about 0.1° to 0.3°, which is similar to a basic torpedo level. Calibrate on a surface you know is level, or use the flip test, and remove a bulky case or camera-bump wobble for the best results.
How do I calibrate the bubble level?
Put the phone on a surface you know is level and tap Set as level. No known-level surface? Use the flip test: take a reading, turn the phone 180° on the same spot and take another. If the readings differ, the surface is not level; the true tilt is the average of the two. The calibration is saved on your phone for next time.
What is the difference between surface and edge mode?
Surface mode is for laying the phone on its back on something flat, like a table, shelf or washing machine, and shows a round bullseye bubble. Edge mode is for standing the phone on one of its edges against something, like the top of a picture frame or a shelf lip, and works like the tube of a carpenter's level.
Does it work on iPhone and Android?
Yes, in Safari on iPhone and Chrome on Android. iPhone asks for permission to use motion and orientation the first time: tap the button, then Allow. Nothing is recorded or sent anywhere.
Can I use the bubble level on a laptop?
Most laptops and desktop computers have no motion sensor, so the level cannot work on them. Open the page on your phone or tablet instead. On a computer, the online protractor measures angles on your screen.
How much slope is "level enough"?
For shelves and pictures, anything under 0.2° looks level. Appliances like washing machines and fridges usually need to be within about 0.5°. Patios and drains need a deliberate slope instead, typically 1/8 to 1/4 inch per foot (about 0.6° to 1.2°); the angle finder shows slope and roof pitch in detail.