How to measure an angle by turning your phone
- Open this page on your phone (iPhone or Android). On iPhone, tap Tap to enable motion sensor and allow access.
- Hold the phone upright, standing on one of its edges with the screen facing you. Lying flat, it cannot sense the turn.
- Press one edge against the first surface and tap Set zero here.
- Turn the phone onto the second surface, keeping the same edge against it. The big number is the angle between the two surfaces.
- Tap Hold to freeze the reading so you can move the phone and read it comfortably.
Angles in an up-and-down plane only. The phone senses gravity, so it measures turns like the hands of a wall clock. It cannot sense turning around a vertical line, like a door swinging or the corner of a room.
No zero set? The meter then measures from level: 0° means the edge you are holding against is horizontal. Edge from level and Edge from vertical always show the phone's own tilt.
What you can measure with an angle meter
| Job | How | Typical angle |
|---|---|---|
| Chair or recliner back | Stand the phone on the seat and tap Set zero, then hold it against the backrest. | 100°–135° |
| Laptop screen | Stand the phone on its edge on the keyboard, zero, then lean it against the screen. | 100°–135° |
| Bent pipe, conduit or rebar | Hold the bend upright, zero along one leg, then turn the phone to the other leg. | 45°, 90° |
| Handrail or ramp | No zero needed: hold the edge along the rail and read Edge from level. | 30°–38° (rail), under 5° (ramp) |
| Rafter or brace | Zero on the ceiling joist or post, then hold the phone along the rafter or brace. | 45° braces, 18°–45° rafters |
| Stretch or joint range | Line up with the upper limb, zero, then line up with the lower limb. | Rough check only |
Angle meter, angle finder or protractor?
- An angle on your screen, in a drawing, PDF or picture: use the online protractor. It is the most precise option and works on any device.
- The angle between two real surfaces: use this angle meter.
- How much a surface tilts, like a roof, a ramp or a saw blade: use the angle finder, which also shows roof pitch and percent slope.
- Checking level or plumb: use the bubble level.
- An angle in a photo: use measure angle from photo.
How it works: your phone's accelerometer
An accelerometer measures acceleration along three axes: X across the screen, Y up the screen and Z out of it. When the phone is still, the only acceleration it feels is gravity, about 9.81 m/s² (1 g), so the three readings tell the phone exactly which way is down. You can watch the raw numbers in the Accelerometer box: stand the phone upright and Y is close to 9.8; lay it flat and Z takes over.
The browser combines the accelerometer with the gyroscope into a steady orientation. This page takes the direction of gravity across the screen and turns it into an angle with a little trigonometry: angle = atan2(x, y). Setting zero stores the current angle, and every reading after that is measured from it, from 0° to 360°. Everything is calculated on your phone; nothing is sent anywhere.
Tips for accurate readings
- Use the same edge for both surfaces, and press it flat so the camera bump does not rock.
- Keep the phone upright. The closer the screen is to vertical, the more stable the reading. The meter warns you when it is too flat.
- Wait a second after moving: the reading is smoothed to hide hand shake.
- Check a known angle, like the top corner of a door frame (jamb against head), which should read close to 90°.
Frequently asked questions
How does a phone angle meter work?
Your phone has an accelerometer that feels which way gravity pulls. When you hold the phone upright and turn it, gravity moves across the screen, and this page converts that into an angle to 0.1°. Set zero on the first surface, turn the phone onto the second, and the difference is the angle between them.
What is the difference between the angle meter and the angle finder?
The Angle Finder measures how much a surface tilts, usually with the phone lying on it. The angle meter measures how far you turn the phone while it stands upright, so it is best for the angle between two surfaces: a chair back, a bent pipe or a rafter. To measure an angle on your screen or in a drawing, use the online protractor.
Can I use the angle meter on a computer?
Yes. Laptops and desktops have no motion sensor, so the page switches to manual mode: drag the needle, scroll the mouse wheel, use the arrow keys, or type an angle. To measure an angle that is on your screen, the online protractor is the better tool.
Why does it tell me to hold the phone upright?
The meter reads the turn of the phone in the plane of its screen. Lying flat, gravity points straight through the screen and that turn cannot be sensed. Stand the phone on its edge, screen facing you. To measure a flat surface, use the bubble level or the angle finder.
Can it measure a door opening or the corner of a room?
No. A phone senses gravity, and gravity does not change when you turn around a vertical line, as a door or a wall corner does. The angle meter works for angles in an up-and-down plane: the phone must turn like the hands of a clock on a wall. For a corner seen from above, take a photo from directly overhead and use measure angle from photo, or use the online protractor on a floor plan.
How accurate is it?
Most phones are good to about ±0.5° when held still against a straight edge. Press the phone firmly against each surface, keep the same edge touching both, and take the reading when the number settles. Tap Hold to freeze it before you move the phone.
Can I measure a knee or elbow angle with it?
You can get a rough reading: line the phone up with the upper leg or arm, tap Set zero, then line it up with the lower leg or arm. It is handy for tracking stretches at home, but it is not a medical device. Ask a physical therapist for clinical measurements.